LTC4258CGW#PBF, POE контроллер, -57В/5мА, -31В пороговое значение блокировки питания при ПН, SSOP-36
The LTC4258CGW#PBF is a quad Hot Swap Controller designed for use in IEEE 802.3af compliant power sourcing equipment (PSE). It consists of four independent ports, each with output current limit, short-circuit protection, complete Powered Device (PD) detection and classification capability and programmable PD disconnect using DC sensing. Used with power MOSFETs and passives, the LTC4258 can implement a complete IEEE 802.3af-compliant PSE. It can operate autonomously or be controlled by an I?C serial interface. Up to 16 LTC4258s may coexist on the same data bus, allowing up to 64 powered Ethernet ports to be controlled with only two digital lines. Fault conditions are optionally signaled with the INT pin to eliminate software polling. External power MOSFETs, current sense resistors and diodes allow easy scaling of current and power dissipation levels and provide protection against voltage and current spikes and ESD events.
• IEEE 802.3af compliant PD detection and classification
• Output current limit with foldback
• Short-circuit protection with fast gate pull-down
• PD Disconnect using DC sensing
• Power good indication
• 4-bit Programmable digital address allows control of up to 64 Ports
• Programmable INT pin eliminates software polling
• Current and duty cycle limits protect external FETs
Полупроводники - Микросхемы\Микросхемы Управления Питанием\Power-over-Ethernet (POE) Контроллеры
Технические параметры
Минимальная Рабочая Температура | 0 C |
Максимальная Рабочая Температура | 70 C |
Частота | 400кГц |
Количество Выводов | 36вывод(-ов) |
Входное Напряжение | 3В |
Стиль Корпуса ИС Контроллера | SSOP |
Блокировка Питания при Пониженном Напряжении | 2.7В |
Вес, г | 0.2 |
Дополнительная вкладка, для размещения информации о магазине, доставке или любого другого важного контента. Поможет вам ответить на интересующие покупателя вопросы и развеять его сомнения в покупке. Используйте её по своему усмотрению.
Вы можете убрать её или вернуть обратно, изменив одну галочку в настройках компонента. Очень удобно.