DRV8860APWR, Привод двигателя, шаговый/DC, 8В до 38В питание, 560мА/8 выходов, TSSOP-16
The DRV8860APWR is an 8-channel serial interface low side driver in 16 pin TSSOP package. It provides an 8-channel low side driver with overcurrent protection and open/shorted load detection. It has built-in diodes to clamp turn-off transients generated by inductive loads and can be used to drive unipolar stepper motors, DC motors, relays, solenoids or other loads. This package can supply up to 200mA ? 8 channel continuous output current. A single channel can deliver up to 560mA continuous output current. A serial interface is provided to control the DRV8860 output drivers, configure internal setting register and read the fault status of each channel. It can be daisy-chained together to use a single serial interface. Energizing-time and holding PWM duty cycles are configurable through serial interface as well. These functions allow for cooler running than always-on solutions.
• Configurable 100% output timing
• Support parallel configuration
• Supply voltage range from 8V to 38V
• RDS(ON) (HS + LS) is 1500mohm
• Input digital noise filter for noise immunity
• Internal data read back capability for reliable control
• Fault information for each channel can be read out through serial interface & indicated by fault pin
Полупроводники - Микросхемы\Микросхемы Управления Питанием\Драйверы и Контроллеры
Технические параметры
Выходной Ток | 560мА |
Минимальная Рабочая Температура | -40 C |
Максимальная Рабочая Температура | 85 C |
Максимальное Напряжение Питания | 38В |
Минимальное Напряжение Питания | 8В |
Количество Выводов | 16вывод(-ов) |
Количество Выходов | 8выход(-ов) |
Стиль Корпуса Привода | TSSOP |
Тип Мотора | шаговый |
Вес, г | 0.145 |
Дополнительная вкладка, для размещения информации о магазине, доставке или любого другого важного контента. Поможет вам ответить на интересующие покупателя вопросы и развеять его сомнения в покупке. Используйте её по своему усмотрению.
Вы можете убрать её или вернуть обратно, изменив одну галочку в настройках компонента. Очень удобно.