The SN74HC191N is a 4-bit synchronous Up/Down Binary Counter operation is provided by having all flip-flops clocked simultaneously so that the outputs change coincident with each other when instructed by the steering logic. This mode of operation eliminates the output counting spikes normally associated with asynchronous (ripple-clock) counters. The outputs of the four flip-flops are triggered on a low- to high-level transition of the clock input if the count-enable (CTEN) input is low. A high at CTEN inhibits counting. The direction of the count is determined by the level of the down/up (D/U) input. When D/U is low, the counter counts up and when D/U is high, it counts down. It features a fully independent clock circuit. Change at the control (CTEN and D/U) inputs that modifies the operating mode has no effect on the contents of the counter until clocking occurs. The function of the counter is dictated solely by the condition meeting the stable setup and hold times.
• Outputs can drive up to 10 LSTTL loads
• 13ns Typical tpd
• Low input current of 1µA Maximum
• Single down/up count-control line
• Look-ahead circuitry enhances speed of cascaded counters
• Fully synchronous in count modes
• Asynchronously presettable with load control
• 80µA Maximum low power consumption
• ±4mA Output drive at 5V
Полупроводники — МикросхемыЛогикаСчетчики
Технические параметры
| Минимальная Рабочая Температура | -40 C |
| Максимальная Рабочая Температура | 85 C |
| Максимальное Напряжение Питания | 6В |
| Минимальное Напряжение Питания | 2В |
| Количество Выводов | 16вывод(-ов) |
| Стиль Корпуса Микросхемы Логики | dip |
| Тип Счетчика | Двоичный, Синхронный, Вверх / Вниз |
| Тактовая Частота | 48МГц |
| Максимальный Счет | 16 |
| Базовый Номер / Семейство Логики | 74HC191 |
| Базовый Номер Микросхемы Логики | 74191 |
| Семейство Логической Микросхемы | 74HC |
| Максимальная рабочая температура | +85 C |
| Количество элементов | 1 |
| Длина | 19.3мм |
| Минимальное рабочее напряжение питания | 2 В |
| Производитель | Texas Instruments |
| Тип корпуса | PDIP |
| Заранее установленный тип | Асинхронный |
| Тип монтажа | Монтаж на плату в отверстия |
| Минимальная рабочая температура | -40 C |
| Ширина | 6.35мм |
| Рабочий режим | Обратный счетчик, суммирующий счетчик |
| Семейство логических элементов | HC |
| Высота | 4.57мм |
| Логическая функция | Счетчик |
| Количество ступеней | 4 |
| Тип пуска | Положительный перепад |
| Максимальное рабочее напряжение питания | 6 В |
| Число контактов | 16 |
| Размеры | 19.3 x 6.35 x 4.57мм |
| Тип счетчика | Двоичный |
| Тип направления | Двунаправленный |
| Вес, г | 1.667 |



